Caterham Seven Manual de usuario descargar pdf (Pagina 179)

Page | 178

Figure 162: Sidescreen straps

1. Sidescreen

2. Vinyl strap

NOTE

Optional arm restraints are available. If

these have been specified on your car

then only the top strap is required to

locate the sidescreen.

Attach a popper base (2) using rivet (1).

Next pull the strap down over the popper

base and mark the centre to position the

fastener. Whilst doing this ensure the

sidescreen is pulled tight up against the

body of the car to reduce draughts and

water ingress. Fix a fastener to the

marked position on the strap using the

durable dot tool, refer to figure 172.

Repeat this process for all fixing straps.

13.4) Arm rest bracket fitment

(escutcheon bracket)

Optional arm rest bracket needs to be

fitted at this stage. SV/CSR cars comes

with arm rest attached to the side screen

(it’s optional on S3). Stick the masking

tape on the interior panel in the middle

over the rivet holes. Hold the side screen

tight against the car and press mark the

arm rest popper position on the masking

tape. Normally the popper line up with one

of the rivet holes on the side panel. Push

fit the escutcheon bracket and line up the

marked position with the centre of the

bracket (Bracket should fit over the inside

panel and rubber trim). Drill the marked

popper position through the bracket (5/32”

drill size). Refer to figure160.

Figure 163: Arm rest bracket

13.5) Exterior mirrors

NOTE

After the IVA inspection, the mirrors may

be fitted to the side screens but in order to

pass IVA inspection, the mirrors must be

fitted to the windscreen stanchions.

13.5.1) Fitment to screen stanchion

Remove and retain the central, slot-head

screw, in the screen stanchion and screw

in the IVA mirror stalk adaptor, refer to Fig

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 226 227

Comentarios a estos manuales

Sin comentarios